Dimmable Crystal Candle Chandelier 1-100 Percent Dimming Triac DALI 0-10V Candle Arm Fixture

Most chandeliers are sold as dimmable and then behave badly at the bottom of the range: a step at ten percent, a buzz at five, a flicker that a phone camera catches immediately. This dimmable crystal candle chandelier is specified around the driver rather than the frame, with a constant current unit that holds a smooth curve from one percent to full output, and a choice of triac, DALI or 0-10V control so the fixture matches whatever system the building already owns. The candle arms are wired in parallel to a single terminal block with numbered cores, which keeps the dimming behaviour consistent across all arms instead of varying arm to arm. Crystal and candle sleeves are unchanged from the standard family, so the dimmable version can sit in the same room as fixed output fixtures without a visual mismatch.

• One Percent Floor: A constant current driver holds a smooth dimming curve down to one percent, avoiding the step and drop out that phase cut drivers show at the bottom of the range
• Triac DALI 0-10V Options: Three driver variants cover trailing edge mains dimming, DALI addressable control and 0-10V analogue systems, so the fixture fits the building rather than the reverse
• Parallel Wired Arms: All arms terminate in a numbered parallel block, keeping output and dimming behaviour consistent across the fixture instead of varying from arm to arm
• Flicker Free At Low Output: Output ripple is controlled so phone cameras and video rigs do not capture banding at low dimming, a common failure in hospitality photography
• Thermal Derating: The driver derates against measured canopy temperature, protecting module life in insulated ceilings where heat has nowhere to escape
• Family Matched Styling: Crystal, candle sleeves and finishes match the fixed output versions, so dimmable and non dimmable units can share one room without visible difference

Specified where the lighting is part of a controlled scene rather than a simple switch: hotel lobbies and ballrooms on DALI, restaurants and bars on trailing edge dimming, and villas with 0-10V home automation. The one percent floor is particularly useful in bars and late night dining rooms, where the fixture needs to drop to a glow without turning off. Integrators also value the numbered terminal block, which lets a commissioning engineer verify each arm during a scene test instead of guessing at wiring.

We confirm the control protocol, dimmer make and model, and the minimum output required, then match a driver variant and supply commissioning notes. Custom options include an emergency battery module, a two channel driver for split circuit scenes, crystal colour variations, and a remote driver for shallow ceiling voids where the canopy cannot house the unit.

The fixture ships with the driver in a separate protected crate or in the canopy depending on the variant, both with wiring diagrams and protocol notes. Crystal travels in labelled padded trays. Every unit is tested across the full dimming range before packing, and the test record including minimum output is supplied in the documents.

Lead time is 20 to 28 days, with driver programming pre set where a DALI address plan is supplied. Spare drivers are stocked for five years and module spares supplied at two percent. Remote commissioning support is available for the first scene set up, and a dimming compatibility sheet covering common European and North American dimmer models is included.